A single event that spans one or more consecutive days. Attendee’s register for the first date-time only

The Power of ANSYS Mechanical: Innovations in 2019


  • May 2, 2019
    11:00 am - 12:00 pm

  Date and time: Thursday, May 2, 2019 11:00 am Pacific Daylight Time (San Francisco, GMT-07:00) Panelist(s) Info: aric.meyer@ansys.com Duration: 1 hour Description: The Power of ANSYS Mechanical: Innovations in 2019ANSYS invests over $200M per year on simulation R&D to continually add new capabilities and upgrades to existing analysis functionality. Check out one of two (more…)

The Power of ANSYS Mechanical: Innovations in 2019


  • April 25, 2019
    8:00 am - 9:00 am

Date and time: Thursday, April 25, 2019 8:00 am Pacific Daylight Time (San Francisco, GMT-07:00) The Power of ANSYS Mechanical: Innovations in 2019ANSYS invests over $200M per year on simulation R&D to continually add new capabilities and upgrades to existing analysis functionality. Check out one of two upcoming live webinars where an ANSYS technical expert (more…)

The Power of ANSYS Mechanical: Innovations in 2019


  • April 23, 2019
    11:00 am - 12:00 pm

Date and time: Tuesday, April 23, 2019 11:00 am Pacific Daylight Time (San Francisco, GMT-07:00) The Power of ANSYS Mechanical: Innovations in 2019 ANSYS invests over $200M per year on simulation R&D to continually add new capabilities and upgrades to existing analysis functionality. Check out one of two upcoming live webinars where an ANSYS technical (more…)

Realistic Medical Implant Optimization By Simulation – Webinar


  • April 25, 2019
    11:00 am - 12:00 pm

REALISTIC MEDICAL IMPLANT OIPTIMIZATION BY SIMULATION Musculoskeletal simulation is coupled with ANSYS structural simulations to optimize the design of medical implants. The set of coupled simulations can be used for virtual prototyping of (1) patient specific and (2) taking into account activities of daily living conditions. The procedure outlined here is a lot more realistic (more…)

Additive Manufacturing in the Hot Seat – Webinar


  • April 11, 2019
    11:00 am - 12:00 pm

ADDITIVE MANUFACTURING IN THE HOT SEAT – WEBINAR DATE: Thursday, April 11, 2019 TIME: 2:00 pm ET/ 11:00 am PT As a low-volume prototyping technology, AM or 3D printing proves itself to be almost unrivaled in the range of forms it can produce at a reasonable cost. However, as AM strives to earn a place (more…)